Judy
Guest
|
 Posted:
Mon Nov 29, 2004 6:02 am Post subject:
Administration - Changing from Sponsor Connections to Active |
|
|
When HIS was installed, we were not using AD. Now I have to change
from SNA Subdomains and sponsor connections to AD. I set up a service
account in the new AD domain; SNAPrint is now running under that
account successfully.
I'm now supposed to "unattach" from the old domain and "reattach" to
the new AD. OK, I can do that, but I'm worried because in the
installation manual it sounds like I can only use AD and enter an OU
if it was done during initial installation. Do I have to completely
reinstall?
I found the installation disk, with HIserver.schema on it. Do I have
to install that? I also found that in the installation manual. Can
you tell I just inherited HIS?
I also found a place in SNA Resource Location Wizard, where I could
check AD and fill in an OU. If I'm supposed to do that, when? Before
or after I unattach/reattach? Right now it's protected, but maybe
that's because all I have done is get SnaPrint running under an AD
service account.
I'd appreciate help, or explicit directions about what I have to do
first. Should I be going back to the original sponsor connection
service account before doing anything else?
What a mess. Thanks for your help.
Judy, The Oldest Living Mainframer
P.S. Jeremy answered my original questions, but that query was too
old for a direct response. |
|
Judy
Guest
|
| Posted:
Thu Dec 02, 2004 6:29 am Post subject:
Re: Administration - Changing from Sponsor Connections to Ac |
|
|
judith.goddard@premera.com (Judy) wrote in message news:<5ee46e3e.0411281602.4f7a1219@posting.google.com>...
| Quote: | When HIS was installed, we were not using AD. Now I have to change
from SNA Subdomains and sponsor connections to AD. I set up a service
account in the new AD domain; SNAPrint is now running under that
account successfully.
I'm now supposed to "unattach" from the old domain and "reattach" to
the new AD. OK, I can do that, but I'm worried because in the
installation manual it sounds like I can only use AD and enter an OU
if it was done during initial installation. Do I have to completely
reinstall?
I found the installation disk, with HIserver.schema on it. Do I have
to install that? I also found that in the installation manual. Can
you tell I just inherited HIS?
I also found a place in SNA Resource Location Wizard, where I could
check AD and fill in an OU. If I'm supposed to do that, when? Before
or after I unattach/reattach? Right now it's protected, but maybe
that's because all I have done is get SnaPrint running under an AD
service account.
I'd appreciate help, or explicit directions about what I have to do
first. Should I be going back to the original sponsor connection
service account before doing anything else?
What a mess. Thanks for your help.
Judy, The Oldest Living Mainframer
P.S. Jeremy answered my original questions, but that query was too
old for a direct response.
|
Never mind. Needed quicker answer, so opened service ticket, and John
Wu answered. Was OK to just migrate and then run Resource Location
Wizard. Thanks John. |
|
FAQ
Memberlist
Register
Profile
Log in to check your private messages
Log in